PDA

Archiv verlassen und diese Seite im Standarddesign anzeigen : Hilfe bei airbagleuchte nach Lenkradwechsel SRS-non SRS bleibt an, trotz Fakestecker



hondasash
25.03.2011, 17:14
Tach,

habe mein ITR SRS Lenkrad gegen ein MOMO getauscht. Klar, SRS-Leuchte bleibt an.
Allerdings habe ich so ein Stecker in den Airbackkontakt gesteckt,der dem Airbag
vorspielen soll, alles wäre i.o.
Stecker ist von Honda, Airbagleuchte müsste ausgehen - Tut sie aber nicht.
Wenn der Fehler aus dem Steuergerät rausgelöscht wird, geht die Airbagleuchte aus..bis ich Zündung aus und wieder an mache..Dann ist der Fehler wieder im Steuergerät und Leuchte bleibt wieder an..
Woran kann das liegen, jemand ne Idee..

habe im Netz was gefunden dazu:

For some unknown reason the SRS light came on.. So I procced to erase it, here's how:

Take out the in-dash fuse cover off.
locate and remove a SMALL yellow 2 pin plug. it's on the right side, near the steering wheel (http://www.clubintegra.com/board/showthread.php?t=9202#), there is other yellow plug but it's larger and on the left side near the hood latch.
Get yourself the almighty paper clip. yes, the same method as check engine (http://www.clubintegra.com/board/showthread.php?t=9202#).
Jump the plug..
turn the ignition on
SRS will go out, take out the paper clip within 4 secs.
SRS will go on again, put it back within 4 secs.
SRS will go out, take out the paper clip and finally SRS light will blink twice confirming that the DTC is erased.

was heisst in diesem Fall jump the plug? die Büroklammer in den Stecker stecken?

MasterR
26.03.2011, 10:35
Hi

Ja hatte das selbe Problem.
Einfach mit Büroklammer kurzschliessen, dann Zündung ein und gemäss Anleitung fortfahren.



Schönes weekend

hondasash
26.03.2011, 11:07
Die Klammer muss nach dem Prozess aber raus, jo? Muss mann danach trotzdem noch n wiederstand einlöten, oder bleibts dann dabei?

Hupe hab ich jetzt ans Laufen bekommen, Internet und HT sei dank.

MasterR
26.03.2011, 11:11
Sorry das kann ich dir nicht sagen.
Kann dir nur betreffend des Löschvorgangs helfen. Wie du Airbag simulierst, das sie dan aus bleibt weiss ich nicht.

hondasash
26.03.2011, 12:21
ok, werde das mal probieren..